Ecast31
Ready to race!
- Location
- Los Angeles
I Finally got my Milltek quad cat back installed. After much anticipation and research. I knew this was going to be the cat back for my car. The cat back is a non-resonated version paired to a 3" 42dd non-cat and non-resonated version dp. The design and build quality is one of a kind. The Clamps and welds are all professionally done with 3" quad stainless tips to add to the cake. Once installed i automatically noticed it was noticeably louder than stock cat back i had and it adds an aggressive rumble at idle. The you tube videos you see of the Milltek audio clips cannot justify the sound at all. Its aggressive rumble is quiet down low while at cruising speeds and once you open her up she screams in a muscled deep tone with minimal drone. The pedal feel is sharper and more torquey and but dyno definitely feels a difference. I'm not entirely sure of how much hp but it's there. The pick up on the freeway is 100% noticeable. I know there have been users reporting that the quad tips are not flowing equally this is partially true. At idle the tips flow equally while driving the the outer tips flow more due to exhaust gas moving freely and directed to least restricted direction. Overall the tips are easy to clean and makes it stand out really well. The rear bumper lower valance must be modified in order to install the milltek quad exhaust. I used the osir gloss carbon fiber valance in conjunction with the exhaust. Pairing the two makes the exhaust nice and snug with the valance. The price, quality, sound, and performance with millteks quad exhaust is superb! Would i recommend it? YES! though everyone is entitled to to their own opinion. This is one of the exhaust to keep in mind. Before i end this review i would like to say i do not affiliate with milltek or it company. I am mainly a consumer with satisfied results.