These photos are of my inlet camshaft. The cylinder head came put of storage and the lobe had slight rust on it.
I used a rag with wd40 to clean it up but its not perfect.
If I use it as is with a new follower with decent synthetic oil will it last or is it dead and should be replaced immediately?
Money always an issue with the project Im busy with so if I dont have to lay out cash that would be preferable.
Thanks
Sent from my SM-N920I using Tapatalk
I used a rag with wd40 to clean it up but its not perfect.
If I use it as is with a new follower with decent synthetic oil will it last or is it dead and should be replaced immediately?
Money always an issue with the project Im busy with so if I dont have to lay out cash that would be preferable.
Thanks
Sent from my SM-N920I using Tapatalk