Pagparts.... It's a tight fit(that's what she said). Once the clamps are drawn together it's ok
found some longer bolts today. bolted it together then removed them and installed the correct ones. Worked pretty well.
got a lot accomplished tonight.
-cut big stupid thick rear coolant line bracket
-waste gate is on.
-dp is on
-oil drain pipe is mounted.
-modified discharge pipe is bolted on
-recirc dv is mounted and vac line ran
to do
-intake is on its way back
-fit/modify/cut rear section of dp before catback
-waste gate vacuum lines
-coolant and oil
-make a block off plug for rear pcv port
figure I might run it on current giac for a minute to make sure the hardware is good. Then Ill switch out to the maestro flash along with TDI map sensor.