Almost there...with a few questions
Hey guys I need some help please.
I wired my Connects2 harness to my F900BT harness and followed our friend quality_sounds instructions and pictures, but I noticed some differences in my Connects2 harness and that's where I need help with.
Here are my questions:
1. Matched color by color all wires from the cut DIN connectors of Connects2 to my HU harness. Differences:
a. Solid orange wire on Connects2 could not be found on HU's harness.
HU however, had a peach/white wire with tag "ILL" and I just went
ahead and connected the two together. Was this right?
b. Green/white wire on Connects2 could not be found on HU's harness.
HU however, had a solid pale green wire with tag "PARKING BRAKE" and
I just went ahead and connected the two together. Was this right?
2. At this point I am left with the following wires whose matchup I wanted to double check:
a. Black wire on Connects2 ending with a fork connector. Black wire on
HU harness, no tags. Should I be cutting the fork connector off and then wire the two together? And what would this be, the ground?
b. Blue wire on Connects2 ending with a female spade connector. Blue wire
on HU harness, tagged "ANTENNA CONTROL". Should I be cutting the spade connector off and then wire the two together?
3. And question 2.b brings me to the last question:
a. Where does the blue wire in the EU-55 aerial adapter go? Is it wired together with the blue wires from Connects2 and HU harnesses, so that you have three blue wires connected together?
Thanks in advance guys, I really appreciate your help. :smile: