Yesterday went ahead and put on the AWE Tuning CCB intake and the 034 Motorsport catch can.
Install was a breeze for the intake, much less so for the catch can. The two main problems were, that one of the bolt holes was striped out and couldn't get the bolt in (it would just rotate freely). The other was because I had an aftermarket engine mount, the bolt that was supplied didn't have a long enough thread on it to fully bolt on the mount and catch can.
The first problem will be dealt with later, the second was solved by putting the catch can in another hole nearby that was there with a smaller bolt and it thankfully worked out perfectly.
Another minor issue is that in the instructions it says that the intake is supposed to be pressed against the air duct of the front. I don't know how that can be achieved since it sits on the bottom of the two mounts with robber grommets and is then bolted in the back. We'll see how I can figure this one out.
Other than that, both products look really great and are definitely high quality. What I would've like more is AWE's instruction manual to also state why, instead of only do this and that, because it gives you a clearer picture of the steps and also doesn't confuse you when you're told to do something.
Other than that, great products from both companies!