But no rush on this one... PICTURES are not of my car, so I don't have Monster Mats :happyanim:
I went to clean out my pollen filter, and a screw just dropped down after I pulled the foam piece out (the one below)
I've found out where the screw comes from (and hence a rattle solved) but I can't figure out how to put it back in without taking the entire glove box out... It screws through an eyelet on the bottom pictured piece unto something behind the glove box (direction -> screwing towards the engine)
It is actually the screw holding the vents on. (The ones picture below)
Any ideas? Guesses....
TIA
I went to clean out my pollen filter, and a screw just dropped down after I pulled the foam piece out (the one below)
I've found out where the screw comes from (and hence a rattle solved) but I can't figure out how to put it back in without taking the entire glove box out... It screws through an eyelet on the bottom pictured piece unto something behind the glove box (direction -> screwing towards the engine)
It is actually the screw holding the vents on. (The ones picture below)
Any ideas? Guesses....
TIA
Last edited: