Whiterabbitwhiterabbit
New member
- Location
- ATX
The three sets of D2S probably worked to begin with, the retainer clips were broken from previous owner. Upon further inspection I noticed electrical tape and even duct tape had been previously applied as well, then learned that the passenger headlamp ECM melted, process of elimination by swapping sides, so that was order used OEM, replaced that and still no cheese. Still before I checked the fuses, I use a test light that shows power so I pull the headlamp apart after reading someone claiming the answer is liquid electrical tape (yes!) but I suppose at a certain point the wires will not hold a current (?) so I will attach the pics from my wallflowers single in repeat the last few weeks and I would appreciate any and all input since my next move is to cut out the wire and try my hand at heat shrink