Engine cover

[tmrakip]

A really stupid question, and most of the search results showed intakes that will have a new engine cover, but how do you take the cover off? I don't see any clips on it anywhere, just the electrical connection up near the top...I'd rather not just rip it off :smile:

 

[Freek]

check out this link..should help ya out

DIY removing the engine cover

 

[alf]

A really stupid question, and most of the search results showed intakes that will have a new engine cover, but how do you take the cover off? I don't see any clips on it anywhere, just the electrical connection up near the top...I'd rather not just rip it off :smile:

ripping it off after disconnecting the MAF is the answer.

 

[tmrakip]

Thanks!

 

[Temper]

Try this one...

http://www.estrictlyforeign.com/asp/product.asp?category=1&ID=1808

 

[kirk180]

You gotta pull hard as hell though. It just has some rubber o-ring type bushings holding it on there at 4 different points. Make sure you have all the rubber rings still attached when you take it off. One of mine fell into the engine area and I had to fish it out.:thumbsup: