Jremey
New member
- Location
- Washington State
- Car(s)
- 2009 gti
How long did it take you to install?
Well unitronic used crinkle band clamps to attach the vacuum hoses to the n75 (wastegate solenoid) so taking those off was a nightmare until I decided to just yank them off. It actually wasn't TOO difficult to get to, but it took around roughly 1.5 hours because of the clamps. I also have some extra plumbing to move that comes with uni's stage 2 kit.
That's funny ↑...I responded to the post I quoted above in post #14, before getting to your post including you fixed it. Anyhow, apologies...been vacant for a bit. Glad you got it solved. I'll try remembering to check in...keep a note of the codes, clear them, then see which if any return. But likely the N75 had something to do with other codes...some at least.
Yah the air intake leak I'm assuming is from the boost gauge tap that runs off the manifold. I think the pcv is recognizing that some air is being siphoned off. The code for the maf I'm assuming is from the Forge Twintake. Though I'm not sure what's causing the lean trim code. Oddly enough I haven't checked the codes again. I'll do that tomorrow.