GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

Dyno'd my DM+ K04 today

NC09gti

New member
Location
High Point, NC
Dyno'd my 2006 GTI , didn't break 300whp:frown:

Dynojet: 295whp/309wtq

My torque seems kind of on the low side but increased after each pull. Thought I share, cheers��

Mods:
DM+ tune
High mileage 151k
Apr k04
Apr intercooler
Uni CAI
S3 injectors
Autotech Hpfp mod
Autotech 3" downpipe and exhaust, no cats
Rev D diverter valve relocation
3 bar map sensor
Ehhh few other mods
 

Attachments

  • 20190518_174125-1209x588.jpg
    20190518_174125-1209x588.jpg
    249.2 KB · Views: 180
Last edited:

GIACUser

Master Wallet Mechanic
Location
USA
Car(s)
MK 6 GolfR
Did you have a fresh set of properly gapped plugs in, fresh air filter and fresh fuel filter?
 

NC09gti

New member
Location
High Point, NC
Did new fuel filter yesterday, I have Uni CAI, filter probably needs clean. The plugs should be gapped right but they have 50k miles on them. Probably due for new set.
 

GIACUser

Master Wallet Mechanic
Location
USA
Car(s)
MK 6 GolfR
Plugs can make a diff. I had about same setup you did, loved my DM tune. I dropped about 15whp going in with old plugs vs new plugs. The gap widens over time as the electrode gets burned off and you end with an ever widening gap.


Sent from my iPhone using Tapatalk Pro
 

GIACUser

Master Wallet Mechanic
Location
USA
Car(s)
MK 6 GolfR
Ok cool, I'll change the plugs next weekend and see if I feel a difference.

I used to run .026 gap and NGK


I dynoed 336/335 but I was running water meth, Later with bad plugs, Just looked it up I put out 310-315whp on that session. Fresh gapped plugs and back up to normal.
 
Top