Some time ago Eurocars told me to use a VDO connector on the oil presure sensor for the oil feed to the gti tubo I'm installing in my NA 2.0 FSi.
This will finally happen next month but looking at the connectors I need some input on the water supply to the turbo.
The gti connector bts onto the block where my engine dont have the connection(blanked off)
Can I t-piece the line running from the metal pipe running over the exhaust manufold going to the internal heater?
The 2 black block pics are from a BWA engine where you can see the feed holes and the other is a BLX like mine where the bottom connting hole is non existent and the top one is blanked off.
Any suggestions?
Sent from my SM-N920I using Tapatalk
This will finally happen next month but looking at the connectors I need some input on the water supply to the turbo.
The gti connector bts onto the block where my engine dont have the connection(blanked off)
Can I t-piece the line running from the metal pipe running over the exhaust manufold going to the internal heater?
The 2 black block pics are from a BWA engine where you can see the feed holes and the other is a BLX like mine where the bottom connting hole is non existent and the top one is blanked off.
Any suggestions?
Sent from my SM-N920I using Tapatalk