Does Stoptech have an electronic handbrake , or does it come separately?
Electronic handbrake? I have a normal e-brake so I don't know what you mean?
Does Stoptech have an electronic handbrake , or does it come separately?
Which 4 piston kit do you have on the rear and where did you get your brackets from? Also, did you require a new handbrake setup?
That's my rear I posted in another thread. Brackets came from an old Vortex group buy, a member used to sell them in limited runs about 3-4 yrs ago.
4 piston caliper is the 17z... might be same rears as Porsche Cayenne S, I don't recall off top of my head. E-brake is from a 2nd gen Viper.
Electronic handbrake? I have a normal e-brake so I don't know what you mean?
That's my rear I posted in another thread. Brackets came from an old Vortex group buy, a member used to sell them in limited runs about 3-4 yrs ago.
4 piston caliper is the 17z... might be same rears as Porsche Cayenne S, I don't recall off top of my head. E-brake is from a 2nd gen Viper.
With my OZ Ultraleggeras I don't need spacers. They're 18x8" and ET 45
Did you have your brackets for the rear custom made?
Trial complete on front. For the factory detroit 18 inch wheel the minimum sized spacer to use is an 8mm(H&R) with the Brembo 355x32, 6 piston kit. This is for a vehicle with VWR sport springs. It clears the calipers by about 2mm. I currently have 5mm spacers on the rear but will try 8mm as well. Spacers larger than 8mm caused the wheels to hit the fender when encountering larger bumps.
Also as an aside, one does not require longer studs. You may choose to use longer Porsche 19mm wheel bolts that come in longer lengths and are black.
I have a 10mm spacer I believe on my 18" detroits. I have the StopTech BBK 328 x 28mm.
I have a 10mm spacer I believe on my 18" detroits. I have the StopTech BBK 328 x 28mm.