hello..please can you help me...on the my mt6501 maisun i not have the usb for ipod..can i soldering the normal usb micro or mini?..the usb on board are blank..excuse for my english but i italian man...i would like soldering usb for ipod o for usb but i not have the schematic or diagram for this usb...usb on board have 10 pin..i woul to say if the 5volt and data - data+ where is...thanks!!
i have a NOWADA GPS card N117 V5
the menu is like the 3rd photo in yr 1st post
it has a problem in it:
sadnly it freeze in the booting screen, but some times it works, like 10 times will not work and one time works
but now is dead, just on the booting screen
when i look on the net i found its datasheet but in chine's
i get mange to know every pin what it is
so i remove it and connect it to a computer screen
Note the boot screen ( navigation system)
I think that the system can't complete reading the main frame program from the flash memory
But what I note too that there is a LED blanking at 1 Hz ( the red one in the photo)
Also there was a Calcareous deposits on the PCB, I clean it but with no successes
Now as you say before that you are work in the NOWADA company, can you help me in any way
Sorry for making this post long
Here is also some photo of my board
cool job there
is wince 6 or 5? i think n117 only come with wicne 6 on it but need to be sure.
if nandflash is not fried, a simple reflash will work, i have the needed firmware. You must add a sd card too, or put it in the unit.
and i don`t work in nowada, i just worked alot with their boards.
Not sure if I'm on the right thread but here goes anyway. I'm having problems with my unit receiving a GPS signal. At first I thought it was just the antenna so I bought a new one. I ran the autodetect option in the IGO program but after scanning for the antenna, it says that no antenna is connected. I have checked the connector on the back of the unit and it has got 3v so is giving power to the antenna. Could it be the GPS card is fried?