GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

My PTE5858

high_octane3541

Go Kart Champion
Location
McKinney, TX
I thought I found the issue

https://vimeo.com/162767479

Added new terminals and a little bit of solder. Went on a test drive and it died :/

On the bright side I did get some fault codes this time

 

high_octane3541

Go Kart Champion
Location
McKinney, TX
Walbro is mounted inside billet basket



I have 1/4 tank.

I should mention that being in neutral and revving to 4K does not cause fuel pressure to drop.
 

high_octane3541

Go Kart Champion
Location
McKinney, TX
Will do. I will feel like a total jackass if that's the issue.

I also couldn't remember how far down the inlet of the pump needed to be in the basket. I currently have mine about an inch from the bottom [emoji85]

I will adjust that too
 

high_octane3541

Go Kart Champion
Location
McKinney, TX
Hows the bottom of that basket work anyway? Check valve or something?







Went ahead and removed the pigtail that was on the walbro pump just incase there was a poor connection inside of there.





The pump was already as far down as it could go in the basket because of the strainer. About a 3/4 inch gap from the bottom of the basket to the inlet of the pump



Kinda ghetto but I rigged it the same way that I had the dw65v so that way I could get it closer to the bottom of the basket



Also added 5gal of gas.

We'll see what happens tomorrow.
 
Top