siliconcenturion
Go Kart Champion
- Location
- Norcal, 94043
I recently upgraded brake pads and discs, so I have my OEM parts left over.
Front and rear pads and rotors are OEM and have about 23k on them. I am looking for 100 picked up for the set, but would be willing to split if there's sufficient interest. Not willing to ship unless you want to pay a hundred dollars in shipping for a hundred dollars of hardware...
EDIT: Sold for $80
Front pads:
ETKA says the thickness new is .55" and the wear limit is .08". My pads are at .4" - plenty of life left. Also, the installer cut the wear sensor to harvest the connector, so you can either cut it completely off and short/code the sensor off, or splice on the connector from your old pad.
Rear pads:
ETKA says the thickness new is .43" and the wear limit is .08". My pads are at .38" - again, lots of life left.
Front rotors:
ETKA says the thickness new is 1.18" and the wear limit is 1.06"
My discs are 1.18" exactly (wut? no wear?) and 1.15". Plenty of life left.
Rear rotors
Thickness new is .87" and minimum thickness is .79"
The rotors are around .86"
You should probably get the rotors resurfaced before installation, which would take off another .01" and cost around 10-20/rotor.
I am also selling a new in box rear wheel bearing. I misdiagnosed a sound coming from the rear of my car, so this bearing was never used. I paid 209.70 for it.
EDIT: SOLD for 180 shipped
If you have any questions or need any more pictures, let me know. :w00t:
Front and rear pads and rotors are OEM and have about 23k on them. I am looking for 100 picked up for the set, but would be willing to split if there's sufficient interest. Not willing to ship unless you want to pay a hundred dollars in shipping for a hundred dollars of hardware...
EDIT: Sold for $80
Front pads:
ETKA says the thickness new is .55" and the wear limit is .08". My pads are at .4" - plenty of life left. Also, the installer cut the wear sensor to harvest the connector, so you can either cut it completely off and short/code the sensor off, or splice on the connector from your old pad.
Rear pads:
ETKA says the thickness new is .43" and the wear limit is .08". My pads are at .38" - again, lots of life left.
Front rotors:
ETKA says the thickness new is 1.18" and the wear limit is 1.06"
My discs are 1.18" exactly (wut? no wear?) and 1.15". Plenty of life left.
Rear rotors
Thickness new is .87" and minimum thickness is .79"
The rotors are around .86"
You should probably get the rotors resurfaced before installation, which would take off another .01" and cost around 10-20/rotor.
I am also selling a new in box rear wheel bearing. I misdiagnosed a sound coming from the rear of my car, so this bearing was never used. I paid 209.70 for it.
EDIT: SOLD for 180 shipped
If you have any questions or need any more pictures, let me know. :w00t:
Last edited:
