GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

Eurocars build thread

projectDIY

New member
Location
UK
New cables are done and installed, had to remove the entire dash and support bar again...






Glad the issue was a simple fix and its up and running properly now. I'm looking at rebuildling my engine harness aswell as I have deleted or altered alot of the OE sensors. What fittings did you use to run the harness through the wheel arches, just standard bulkhead fittings? and did you run them directly into the cabin or into the engine bay and then the gabin. I'm trying to determine the best route but there are so many wires.
 

snobrdrdan

former GTI owner
That'd be a cool upgrade.

But you pretty much had the car finished, finally, and now it's going to go back under the knife again & back to "under construction" status?
#theneverendingstory
 
Top