hey guys, im starting to part out, i have a full TBE from apr that i just took off. im looking for around 900 bucks for it but im negotiable. in good shape, i would recommend buying new clamping sleeves but thats pretty minimal. i can forward pictures if needed.
thanks!
adam
just picked up a 100 watt "power horn" loudspeaker from radioshack, wired it to a audio input jack, bought a cheap cb radio with a PA setting and hooked it up to the 12 v outlet, threw the "power horn" under the hood and ran the cable to the cb, and now i have a fully functioning PA system in my...
so on the way back from a bmx competition in columbus we stopped on polaris parkway to get a bite to eat (for anyone who doesnt know, polaris is a long strip of food places just off of the main interstate I-71) so heading back to 71 i was at a stop light and my friend was next to me and we...
i was driving home from a friends in kent on route 8 south and this obnoxiously bright yellow lexus pulls up next to me and starts revving on the highway so i laugh and keep driving and he keeps getting next to me so of course i promptly downshift to 4th and instantly pull a couple bus lengths...
ordered an insert awhile back, but i didnt realize that the FSI and TSI inserts were different. long story short i got the TSI insert so i have a brand new FSI insert sitting in my garage. any takers?
Im at a bit of fork with mods, im leaning towards water/meth, lsd, shortshifter, twintercooler, bshtrueseal intake catchcan etc. or cosmetic mods, what do you guys think? performance wise what mods should i go with first? thanks for the input guys!
so i have installed my awe ko4 kit and i have put in a 90 deg o2 spacer, but no matter how i orient it i still get a cel for too lean. anyone have any picture of how their spacer is installed? should i try a shorter o2 spacer that doesnt have the 90 deg bend in it? ive taken it out for now and...
so i just installed ko4 kit and im trying to figure out what is causing this problem. it only happens when the car is pretty cool and i havent driven it too hard maybe for 15-20 min after start up. so ill be getting on the highway in 3rd gear, and floor it and the boost gauge will spike to 30...
hey does anyone know how to remove the intake heatshield on the back of the TSI motor? ive finished installing the Ko4 turbo with the heatshield on but i want to remove it and make sure everything is tightened down and possibly fabricate a new one. also does anyone know if the eurojet heatshield...
hey guys i just installed my ko4 and my ecu is on its way back to me. but the guy at auto assets said that i need to install the ecu and turn the key to accessory mode and use a vag com to clear all codes before starting the engine. so my question is, is there anyone near me (north east ohio)...
"Before restarting the engine for the first time, the engine, oil lines and turbocharger must be primed
with oil. To perform this procedure, first locate the engine ECU and disconnect the multipin connectors
from the ECU. Next turn the ignition to the RUN position and crank the starter motor...
Just ordered my AWE ko4 kit today, gonna be starting to take the old one out of my car and getting it ready so i can just bolt that baby on when i get it! super excited and ready to get to it! ill update with pictures and maybe some videos as it goes along but i have to wait for the kit to...
so me and a buddy did the clutch on my car awhile back, installation went pretty smooth so a few days after i start to hear a clatterring sound coming from the transmission when my clutch is engaged in neutral. when i depress the clutch pedal the clattering stops. this sound is almost amplified...