GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

Search results

  1. G

    WTB: Stock TBE stock exhaust in central Texas

    Looking to buy stock dp and exhaust somewhere in central TX
  2. G

    FS: Miltek TBE Exhaust in Texas

    Miltek TBE Exhaust with 4k on it, no low ball offers I will take $800 with the stock exchange or $1000 w/o the stock exhaust, (firm)
  3. G

    Feeler: Miltek tbe resonated

    I want $1000 plus a stock exhaust! 4,000 miles on the exhaust great system
  4. G

    Brakes Question

    Any DIY for replacing the brake fluid? Anybody heard anything bad or good about ATE brake fluid? :smile:
  5. G

    FS: GTI MKV $14,000 Need this gone

    In Austin texas white with cloth intetrior 6 speed. Great car 45k on the car need to sell $14,000 this is way below blue book. Contact Josh 818442-7301!
  6. G

    2006.5 mkv gti

    This is a white 2006.5 2 dr GTI. It has the 2.0l FSI turbo motor in it. It is Candy White with Cloth interior, stick shift. Call Josh 818-442-7301 CAR HAS NO MODS 100% STOCK Car is very very very clean! Asking 15,500, with 45k on it. PM FOR PICS! Serious Inquiry Only!
  7. G

    Cam Follower

    Anyone know where there is a cam follower DIY? Is the follower behind the fuel pump? Is it easy to take out and inspect? Should I just use a fuel pump DIY? :headbang:
  8. G

    DIY cam follower

    Anyone have a link for this or should I just use the fuel pump DIY? Is the follower easy to get out and is it behind the fuel pump?
  9. G

    Fuel Cuts or What?

    Ok so I have had this problem forever. I just replaced the dv valve. Anyway the car does this while it is cold it is all good once it is at operating temp, in 4th, 5th, 6th gear at WOT its crazy. It feels like a cut in power for like a milisecond and them it is fine. It sometimes happens and...
  10. G

    Bad Milltek cat?

    I took my car into the dealer for some issues, when they ran diag. they told me my cat was bad. The problem I am having is not being able to boost over 6 psi. This in giac pump gas mode and stock mode. There is no hesitation with the engine it is running fine (except 5 psi). Now today the check...
  11. G

    Check Engine Light

    Guys when the check engine light comes on is that an cat problem or is it the cat when the check engine is blinking? :barf:
  12. G

    Vag-Com Log Help!

    3 Faults Found: 004243 - Bank 1; Fuel Measuring System 2: Malfunction P1093 - 008 - Implausible Signal - Intermittent Freeze Frame: Fault Status: 00101000 Fault Priority: 0 Fault Frequency: 27...
  13. G

    FINALLY MAYBE SOME HELP?

    A BUDDY OF MINE LOANED ME A VAG-COM. I HAVE NEVER USED IT BEFORE. SOME HELP READING THESE CODES WOULD BE GREAT! BEEN TRYING TO GET RID OF THIS PROBLEM FOR OVER 2 MONTHS. PROBLEM IS LOSS OF BOOST ON FULL THROTTLE. 3 Faults Found: 012599 - Intake Manifold Runner Control: Basic Setting not...
  14. G

    NEED STOCK SHIFT KNOB

    ANYONE HAVE A SHIFT KNOB FOR SALE. STOCK IS FINE. HIT ME UP, IF SO.
  15. G

    Is this Normal?

    Sup guys in vdub land this may be a dumm question, but i cant figure this out so in recent post i have had boosting issues. i noticed today with traction control off that with giac chip in 1st= 12psi 2nd=14psi 3rd=15psi 4th= 16psi 5th=17-18psi 6th=18-19psi. Keep in mind I am very new to 2.0t...
  16. G

    giac problem or what?

    I have posted the same problem a couple times. I just got my giac reflashed, when i give it full throttle in 3-6th gear it slips boost by 2-3psi. It only happens sometimes it seems to happen when engine gets hot. I can not tell if it happens in 1st or 2nd cause the fucking tires are spinning. or...
  17. G

    this has to be the dv!

    OK guys i got a good one for you. I just got back from getting my car chipped from GIAC and when i put the pedal to the floor my boost gauge reads 17 psi and then hesitates. The hesistation only lasts for one sec and only happens on full throttle. I think that its the dv valve but i dont...
  18. G

    MILLTEK RESONATED?

    Whats up guys, I new to the site and just bought an 06 gti on saturday. it already had some mods. one of those mods it milltek tbe resonated. i guess the guy who had the card before me did not want too loud. my question is do you think if i cut resonator off and weld a pipe that size if will...
Top