Eurocars build thread

[Elliott]

Yes Eric! I’m glad to see your still involved!

 

[eurocars]

Figured it out, didn’t add resistors in for the DV/WG solenoid when i built the new harness. Added wires back in for them, boost is back

 

[snobrdrdan]

Would like a burnout video for confirmation, and science, of course

 

[projectDIY]

New cables are done and installed, had to remove the entire dash and support bar again...

Glad the issue was a simple fix and its up and running properly now. I'm looking at rebuildling my engine harness aswell as I have deleted or altered alot of the OE sensors. What fittings did you use to run the harness through the wheel arches, just standard bulkhead fittings? and did you run them directly into the cabin or into the engine bay and then the gabin. I'm trying to determine the best route but there are so many wires.

 

[eurocars]

The holes are already behind the fenders, i just added grommets for the wires. There are two 12 pin Deutsch connectors on the interior side

 

[RSMark5]

Hey Terry.

 

[eurocars]

Hey Terry.

Hi Mark

 

[RSMark5]

Your car is looking great man!

 

[eurocars]

Thanks man. Took some pics this evening, I’ll post up after editing

 

[eurocars]

 

[RSMark5]

Yeah, thats looking great man! Still stuck with those CH's huh? Crazy how times change. I think I like them again.

Hope ol' Max's car is looking similar.

 

[eurocars]

Max's car ran for a little while but now its back under the knife for some more goodies

 

[drtechy]

i never really understood the rear wiper delete. its not hurting anything back there.

It's such a cleaner look without it

 

[eurocars]

Found some stuff at the yard today

 

[snobrdrdan]

That'd be a cool upgrade.

But you pretty much had the car finished, finally, and now it's going to go back under the knife again & back to "under construction" status?
#theneverendingstory