mike-y's latest activity

Is this the proper amount of water that the horns should be holding?

How would you attach/bond the CF to the plastic? maybe just glue or epoxy would work? Working with CF is a bit tricky, and just FYI...

My issue here was the amp I was using, it didnt support signal input. As soon as swapped to an amp that did everything was fine.

Put on a new set of Michelin Pilot Port 4S tires. Also installed some vland tails. Using ZERO815’s instructions were perfect and made...

me neither i'm shitposting on car forums

I always use a waterless wash and wax spray or detailing spray and a microfiber towel. After having bird droppings destroy my clearcoat...

you might have broken little parts of your clutch disk, and they are affecting shifts. THough usually if would affect every gear...

Like others said, you can try some polishing compound, or take it to a detailer, and have them work some magic in that area. in the...

ebay has OEM xenon headlights going for $400-$600ish for each side. that might be a better route to go. I did see Xenon headlights on...

Not in D. In S mode, there might be a couple of times where the car hangs on to 3rd gear for a bit too long when you are just cruising...

I had the IE DSG tune in my old GTI, and didn't like how if you were slowing down, it didn't downshift to a lower gear until you were...

I have them on my 16 R. The valving is definitely more comfortable than the factory non-DCC struts, but they do not ride like a limo...

Holy shit holy shit holy shit holy shit holy shit. You guys. It seems that last round of sound deadening killed the hum on the highway...