GOLFMK8
GOLFMK7
GOLFMK6
GOLFMKV

Tools Needed~

ryaaannnn

Passed Driver's Ed
Location
Chantilly, VA
Car(s)
2008 Nissan Xterra S
Hey is there anyone in the Northern V.A area that has a 1.) VW Tool 3424 (strut spreader tool), 2.) The 14mm triple square needed to remove the bolt from the knuckes.

PICS:
1.)

2.)



Just wondering if I could borrow/rent this from you? I would pick it up from your place and bring it back after were done. I just need it for tomorrow because im trying to install my H&R race springs on my car..
 

ryaaannnn

Passed Driver's Ed
Location
Chantilly, VA
Car(s)
2008 Nissan Xterra S
nvm! did the install today! and we just used the t-60 torx for the m-14(triple square) and we just took out the whole strut tower and where it was connected so we didnt have to take the strut out! everything went smooth only problem was we snapped the 1 bolt from the ball joint.. the one under the axle bolt, the little triangle thing with 3 bolts on it. so right now im just running with 2! hope it holds till i get a replacement..

anyways, il try to post pics for before and after the install~
 
Top