g60_corrado_91
Go Kart Champion
- Location
- IL
- Car(s)
- 2006 GTI 6MT Pkg 1
Ah lol.
V
The Golfmk OFF-TOPIC chat (Part 11)
- Thread starter eurocars
- Start date
well my rehearsal dinner is at the KofC on liberty and bull and from there we are just gonna wonder around and drink and troll
so Ruger LC9s, xds-9, Glock 43, (add your other gun here) for concealed carry options for the lady. I currently carry a Glock 30 for mine but I'm looking to either get a Glock 36 or an xds-45. I prefer to carry 45acp but my fiancee likes 9mm better. Anyone have any input on this?
live4something
Ready to race!
- Location
- Lawton, OK
g60_corrado_91
Go Kart Champion
- Location
- IL
- Car(s)
- 2006 GTI 6MT Pkg 1
Holy shit that's sketchy.
RSMark5
Go Kart Champion
- Location
- Jacksonville NC
uhhhh yeah, i'd say thats broke.
live4something
Ready to race!
- Location
- Lawton, OK
Yes and Yes. Now to see if it jumped...didn't get a CEL, idled fine. I'll get the motivation to go in the garage and tear it apart after lunch
merkeyterkey
The Real FLATTIRE
- Location
- Pawnee, IN
Fucking delta wing ftw
RSMark5
Go Kart Champion
- Location
- Jacksonville NC
I feel like I should know this, but the 2.0T's are interference motors right? Of course they are
g60_corrado_91
Go Kart Champion
- Location
- IL
- Car(s)
- 2006 GTI 6MT Pkg 1
Yes. Boom
live4something
Ready to race!
- Location
- Lawton, OK
Hah yea. It didn't jump at all, but the dick ng tensioner is stuck on. Idk wtf is going on. The stud doesn't move, the nut does...but it won't loosen or tighten
Sent from my XT1254 using Tapatalk
Sent from my XT1254 using Tapatalk
g60_corrado_91
Go Kart Champion
- Location
- IL
- Car(s)
- 2006 GTI 6MT Pkg 1
Does it have an Allen key inside the nut (on the bolt side)?
I didn't DIY mine.
I didn't DIY mine.
live4something
Ready to race!
- Location
- Lawton, OK
Nope
RSMark5
Go Kart Champion
- Location
- Jacksonville NC
Have you tried turning it off and turning it back on again?
live4something
Ready to race!
- Location
- Lawton, OK
Yea, the nut doesn't move in either direction. I will just use an extractor once I know if the stud is easily replaced(i.e. threaded into the block). I would think it is