lightningjack
Go Kart Champion
- Location
- Westchester, NY
- Car(s)
- 09 GTI
Got misfiring on 3 cylinders the other day. Put in 3 new coil packs, cleared codes was fine for a day. Started the car after work, EPC light comes on.
I get 2 codes;
1 Fault Found:
01314 - Engine Control Module
013 - Check DTC Memory
Freeze Frame:
Fault Status: 01101101
Fault Priority: 2
Fault Frequency: 1
Reset counter: 57
Mileage: 77602 km
Time Indication: 0
Freeze Frame:
Count: 0
Count: 14
Count: 12800
Count: 8193
Count: 50176
Count: 0
Count: 0
Count: 0
1 Fault Found:
000545 - Angle Sensor 2 for Throttle (G188)
P0221 - 000 - Implausible Signal - MIL ON
Freeze Frame:
Fault Status: 11100000
Fault Priority: 0
Fault Frequency: 1
Mileage: 77602 km
Time Indication: 0
Date: 2000.00.00
Time: 18:50:41
Freeze Frame:
RPM: 1149 /min
Load: 27.0 %
Speed: 0.0 km/h
Temperature: 41.0°C
Temperature: 34.0°C
Absolute Pres.: 1010.0 mbar
Voltage: 14.224 V
Readiness: 0000 0000
Where specifically is the ECM and TB located on our cars? What are the odds a bad battery or bad tank of gas is causing this? Also the ECM issue is under ABS brakes on the scan?
Any and all help is greatly appreciated.
I get 2 codes;
1 Fault Found:
01314 - Engine Control Module
013 - Check DTC Memory
Freeze Frame:
Fault Status: 01101101
Fault Priority: 2
Fault Frequency: 1
Reset counter: 57
Mileage: 77602 km
Time Indication: 0
Freeze Frame:
Count: 0
Count: 14
Count: 12800
Count: 8193
Count: 50176
Count: 0
Count: 0
Count: 0
1 Fault Found:
000545 - Angle Sensor 2 for Throttle (G188)
P0221 - 000 - Implausible Signal - MIL ON
Freeze Frame:
Fault Status: 11100000
Fault Priority: 0
Fault Frequency: 1
Mileage: 77602 km
Time Indication: 0
Date: 2000.00.00
Time: 18:50:41
Freeze Frame:
RPM: 1149 /min
Load: 27.0 %
Speed: 0.0 km/h
Temperature: 41.0°C
Temperature: 34.0°C
Absolute Pres.: 1010.0 mbar
Voltage: 14.224 V
Readiness: 0000 0000
Where specifically is the ECM and TB located on our cars? What are the odds a bad battery or bad tank of gas is causing this? Also the ECM issue is under ABS brakes on the scan?
Any and all help is greatly appreciated.