Need help locating tdc on flywheel

I'm doing my timing belt and I think the cam may have skipped a tooth while removing the old belt. The crank didn't move but I want to be sure the cam was in the right position to begin with. Where is the slot to locate tdc on the flywheel on the mkv? Thanks!

Sent from my SM-G935V using Tapatalk

Other end of crankshaft, marks are on your pulley and timing cover.

http://bd8ba3c866c8cbc330ab-7b26c6f...agen_2.0T_FSI_Timing_Belt_Installation_R1.pdf

I've been using that pdf. I found the mark on the pulley but not on the timing cover.

Sent from my SM-G935V using Tapatalk

I found it after cleaning with some brake cleaner. So it looks like it was off before I took the belt off. The cam is back a tooth and the crank appears forward a few teeth which I assume is normal since every one rotation of the crank is half a rotation for the cam correct? So do I move them or put the belt on as is?

Sent from my SM-G935V using Tapatalk

Anybody know? The cam is back a tooth and the crank is forward a few teeth? Should I move them and if so do I start with the cam or crank?

Sent from my SM-G935V using Tapatalk