Recent content by Denied

Thanks guys! Got it all back in time, did a valve adjustment and shes good as new! Ready to swap the trans over and drop her in!

So Im in the process of refreshing a new motor to drop in my car that spun a bearing and I f**cked up. Had diy’s and procedures in hand but the shop got busy with friends and family coming in and out and I just got distracted and careless. Went to take off the crank pulley after removing the 6...

Think I sent a rod bearing and most likely bent some valves messin around with tc off in the rain yesterday. Need to swap the motor asap and had a few questions I was hoping you guys could help me with. First off, are the tfsi’s found in the eos our exact same motor? Was doing some searching on...

Awesome man aslong as that fitting comes out Ill take it! I have a new one ready to go anyway. Pm me and we can figure out the details

That would be great how much would you want for it?

Thanks but I have a new bleeder its just now I have it cut flush with the fuel pump and theres no basically no getting it out without damaging the outer plate.

Schrader valve on my hpfp stripped today. Whoever tightened it last had to of blasted it on with an impact. Cut the valve off to ez out the inner threads and then snapped too.. Looking for a used pump or if someone has a bad one I really just need the outer plate the valve threads into.

Hey guys. So my dumbass ruined my rear r32 swap exhaust surround today. I've yet to see my exhaust guy yet since the swap and needed to pass inspection so I bolted my suitcase back up. I should of removed the piece surrounding the exhaust as it was rubbing on the tips but for the hour I'd be...

Hey guys! So with all the snow recently my car has started taking on water. A lot of water :( Both my front footwell carpets get a little damp and my rears get completely soaked, I mean press down and water rises up over your hand soaked. Pulled out the boot carpet and my spare tire well was...

Hey guys so 2 pieces on my windshield washer lines broke on me after having my hood latch fail and my hood fly up on me doing 80 on the highway. I found the pieces I need from VW's part diagram (attached) however I cant click on the parts to get the part number for whatever reason and I cant...

Has anyone ever experienced this before? Tac and speedo are fine but both the fuel and temp had this happen at apparently the same time. Almost looks like moisture somehow got in there. anyone have any ideas on how to correct it? Link to pic- https://imgur.com/kDTo8GL

I'm currently on solowerks coils all the way down with perches out in the rear and I'm still not happy with the drop. Before I go about switching up the entire suspension again I figured id check here first. I honestly don't care which version of racelands as long as they can go down to 4"...

Hey guys so while finishing the install of some new axles as well as ecs's aluminum lca's w/ poly bushings I ran into an issue with the 3 lca ball joint nuts. I started with the inner single nut and it torqued to 75 lbs no problem. The next one basically felt like it stripped out before it...

Hey guys, I've been fighting this wobble for quite awhile now and i'm running out of ideas. After lowering the car (about 2 inches) I've developed a side to side wobble in the front end. On smaller roads I don't notice it nearly as much but once I get to around 80 on the highway it can get...

Hey guys! I'm in the process of installing my coilovers and I just need a little advice. I jumped into this project with pretty much 0 suspension knowledge but I wanted to learn so I decided to take it slow and make it a 2 day project. Today was the rear and after a slightly frustrating 2 1/2...